Configure GAS Authentication
Revision as of 18:34, 11 May 2015 by KNO (Talk | contribs) (Text replacement - "{{UBIKSTUDIO}}" to "{{UBIK Studio}}")
Using the Global Application Service (GAS) authentication mode requires to configue the UBIK® Studio as well as the UBIK® web service.
- Open UBIKSTUDIO and connect to the database which should be configured for GAS.
- Open database specific settings and set
| Parameter | Value | Comment |
|---|---|---|
| SessionManagementType | 2 | 0 = Local Management, 1 = LAS, 2 = GAS |
| SessionServiceUrl | https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP?? | Address of the authentication service The port number PORT must be specified only if other than 443 (default for https). |
- Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
- Open the web.config of the GAS' USAM service:
- the settings in the configuration file are the same as in a data service
- however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored
<appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
...
</appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
...
</appSettings>
 | This authentication mode is not yet supported! |
