Last modified on 31 October 2013, at 10:09

Configure GAS Authentication

Revision as of 10:09, 31 October 2013 by BMA (Talk | contribs)

A Global Application Service (GAS) can be configured in the following way:

  1. Open UBIK Studio and connect to the database which should be configured for GAS.
  2. Open database specific settings and set
    3. Parameter Value Comment
    SessionManagementType 2 0 = Local Management, 1 = LAS, 2 = GAS
    SessionServiceUrl https://SERVERNAME/UBIK/USAM.svc/SOAP?? Address of the authentication service
  1. Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
    2.   <appSettings>
        ...
        <add key="UBIK.Service.SessionManagementType" value="2" />
        <add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
        ...
      </appSettings>
  2. Open the web.config of the GAS' USAM service:
    • the settings in the configuration file are the same as in a data service
    • however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored