Last modified on 21 July 2015, at 11:23

Configure Single Local Application Authentication

Revision as of 11:23, 21 July 2015 by KNO (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Using the Single Local Application authentication mode requires to configue the UBIK® Studio as well as the UBIK® web service.

  1. Open UBIK® Studio and connect to the database which should be configured for Single Local Application.
  2. Open database specific settings and set
    3. Parameter Value Comment
    SessionManagementType 0 0 = Single Local Management, 1 = LAS, 2 = GAS
    SessionServiceUrl - Address of the authentication service
    TokenValityPeriode 300 Duration (in seconds) every generated token is valid. The token expires after this timespan.
    HideAuthenticationInfo 1 This switch provides the possibility to turn off the detailed error information as necessary (due to security issues).
  1. Open the web.config of the data service and check values of the session's management type and URL.
    2.   <appSettings>
        ...
        <add key="UBIK.Service.TokenValityPeriode" value="600" />
        <add key="UBIK.Service.SessionManagementType" value="0" />
        <add key="UBIK.Service.SessionManagementUrl" value="" />
        <add key="UBIK.Service.HideAuthenticationInfo" value="0" />
        ...
      </appSettings>

See also