Configure GAS Authentication

Using the Global Application Service (GAS) authentication mode requires to configue the UBIK^® Studio as well as the UBIK^® web service.

1. Open UBIKSTUDIO and connect to the database which should be configured for GAS.
2. Open database specific settings and set

Parameter	Value	Comment
SessionManagementType	2	0 = Local Management, 1 = LAS, 2 = GAS
SessionServiceUrl	https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP??	Address of the authentication service The port number PORT must be specified only if other than 443 (default for https).

3. Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
  <appSettings>
    ...
    <add key="UBIK.Service.SessionManagementType" value="2" />
    <add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
    ...
  </appSettings>
4. Open the web.config of the GAS' USAM service:
   
   • the settings in the configuration file are the same as in a data service
   • however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored

This authentication mode is not yet supported!

See also

• USAM
• Single Local Application
• Local Application Service