Difference between revisions of "HowTo:Configure GAS Authentication"
| Line 1: | Line 1: | ||
Using the [[USAM#LAS_(Global_Application_Service)|Global Application Service (GAS)]] authentication mode requires to configue the {{UBIKSTUDIO}} as well as the [[UBIK_Web_Service|{{UBIK}} web service]]. | Using the [[USAM#LAS_(Global_Application_Service)|Global Application Service (GAS)]] authentication mode requires to configue the {{UBIKSTUDIO}} as well as the [[UBIK_Web_Service|{{UBIK}} web service]]. | ||
| − | |||
<ol> | <ol> | ||
<li>Open UBIKSTUDIO and connect to the database which should be configured for GAS.</li> | <li>Open UBIKSTUDIO and connect to the database which should be configured for GAS.</li> | ||
| Line 14: | Line 13: | ||
|} | |} | ||
</ol> | </ol> | ||
| − | + | <ol start="3"> | |
| − | <ol> | + | |
<li>Open the [[UBIK Web Service Configuration|web.config]] of the data service and set the session's management type and URL to the according address of the web service.</li> | <li>Open the [[UBIK Web Service Configuration|web.config]] of the data service and set the session's management type and URL to the according address of the web service.</li> | ||
<source lang="xml"> | <source lang="xml"> | ||
Revision as of 09:26, 5 June 2014
Using the Global Application Service (GAS) authentication mode requires to configue the UBIKSTUDIO as well as the UBIK® web service.
- Open UBIKSTUDIO and connect to the database which should be configured for GAS.
- Open database specific settings and set
| Parameter | Value | Comment |
|---|---|---|
| SessionManagementType | 2 | 0 = Local Management, 1 = LAS, 2 = GAS |
| SessionServiceUrl | https://SERVERNAME/UBIK/USAM.svc/SOAP?? | Address of the authentication service |
- Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
- Open the web.config of the GAS' USAM service:
- the settings in the configuration file are the same as in a data service
- however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored
<appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
...
</appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
...
</appSettings>
 | This authentication mode is not yet supported! |
