Difference between revisions of "HowTo:Configure GAS Authentication"
(→See also) |
|||
| Line 32: | Line 32: | ||
== See also == | == See also == | ||
* [[USAM]] | * [[USAM]] | ||
| − | * [[USAM| | + | * [[USAM#LAS_.28Local_Application_Service.29|Local Application Service]] |
[[Category:How-To]] | [[Category:How-To]] | ||
Revision as of 07:36, 5 June 2014
A Global Application Service (GAS) can be configured in the following way:
- Open UBIK Studio and connect to the database which should be configured for GAS.
- Open database specific settings and set
| Parameter | Value | Comment |
|---|---|---|
| SessionManagementType | 2 | 0 = Local Management, 1 = LAS, 2 = GAS |
| SessionServiceUrl | https://SERVERNAME/UBIK/USAM.svc/SOAP?? | Address of the authentication service |
- Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
- Open the web.config of the GAS' USAM service:
- the settings in the configuration file are the same as in a data service
- however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored
<appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
...
</appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
...
</appSettings>
 | This authentication mode is not yet supported! |
