Difference between revisions of "HowTo:Configure Single Local Application Authentication"

Revision as of 18:33, 11 May 2015

Using the Single Local Application authentication mode requires to configue the UBIK^® Studio as well as the UBIK^® web service.

Open UBIK^® Studio and connect to the database which should be configured for Single Local Application.
Open database specific settings and set

Parameter	Value	Comment
SessionManagementType	0	0 = Single Local Management, 1 = LAS, 2 = GAS
SessionServiceUrl	-	Address of the authentication service
TokenValityPeriode	300	Duration (in seconds) every generated token is valid. The token expires after this timespan.
HideAuthenticationInfo	1	This switch provides the possibility to turn off the detailed error information as necessary (due to security issues).

Open the web.config of the data service and check values of the session's management type and URL.

@@ Line 1: / Line 1: @@
-Using the [[USAM#GAS_(Single_Local_Application)|Single Local Application]] authentication mode requires to configue the {{UBIKSTUDIO}} as well as the [[UBIK_Web_Service|{{UBIK}} web service]].
+Using the [[USAM#GAS_(Single_Local_Application)|Single Local Application]] authentication mode requires to configue the {{UBIK Studio}} as well as the [[UBIK_Web_Service|{{UBIK}} web service]].
 <ol>
-<li>Open {{UBIKSTUDIO}} and connect to the database which should be configured for Single Local Application.</li>
+<li>Open {{UBIK Studio}} and connect to the database which should be configured for Single Local Application.</li>
 <li>Open [[UBIK_Studio_Basics#Database_specific_settings|database specific settings]] and set</li>
 {| class="wikitable" | width = "50%"