Difference between revisions of "HowTo:Configure GAS Authentication"

Revision as of 15:42, 2 February 2015

Using the Global Application Service (GAS) authentication mode requires to configue the UBIKSTUDIO as well as the UBIK^® web service.

1. Open UBIKSTUDIO and connect to the database which should be configured for GAS.
2. Open database specific settings and set

Parameter	Value	Comment
SessionManagementType	2	0 = Local Management, 1 = LAS, 2 = GAS
SessionServiceUrl	https://SERVERNAME/UBIK/USAM.svc/SOAP??	Address of the authentication service

3. Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
  <appSettings>
    ...
    <add key="UBIK.Service.SessionManagementType" value="2" />
    <add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
    ...
  </appSettings>
4. Open the web.config of the GAS' USAM service:
   
   • the settings in the configuration file are the same as in a data service
   • however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored

This authentication mode is not yet supported!

See also

• USAM
• Single Local Application
• Local Application Service