Difference between revisions of "HowTo:Configure GAS Authentication"
| Line 14: | Line 14: | ||
</ol> | </ol> | ||
<ol start="3"> | <ol start="3"> | ||
| − | <li>Open the [[ | + | <li>Open the [[Web Service Configuration|web.config]] of the data service and set the session's management type and URL to the according address of the web service.</li> |
<source lang="xml"> | <source lang="xml"> | ||
<appSettings> | <appSettings> | ||
| Line 23: | Line 23: | ||
</appSettings> | </appSettings> | ||
</source> | </source> | ||
| − | <li> Open the [[ | + | <li> Open the [[Web Service Configuration|web.config]] of the GAS' USAM service:<br/> |
* the settings in the configuration file are the same as in a data service | * the settings in the configuration file are the same as in a data service | ||
* however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored | * however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored | ||
Revision as of 08:24, 26 February 2015
Using the Global Application Service (GAS) authentication mode requires to configue the UBIKSTUDIO as well as the UBIK® web service.
- Open UBIKSTUDIO and connect to the database which should be configured for GAS.
- Open database specific settings and set
| Parameter | Value | Comment |
|---|---|---|
| SessionManagementType | 2 | 0 = Local Management, 1 = LAS, 2 = GAS |
| SessionServiceUrl | https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP?? | Address of the authentication service The port number PORT must be specified only if other than 443 (default for https). |
- Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
- Open the web.config of the GAS' USAM service:
- the settings in the configuration file are the same as in a data service
- however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored
<appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
...
</appSettings>
...
<add key="UBIK.Service.SessionManagementType" value="2" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
...
</appSettings>
 | This authentication mode is not yet supported! |
