Jump to: navigation, search

Difference between revisions of "HowTo:Configure Single Local Application Authentication"

Line 37: Line 37:
  
 
[[Category:How-To]]
 
[[Category:How-To]]
 +
[[Category:Installing]]

Revision as of 12:06, 30 June 2014

Using the Single Local Application authentication mode requires to configue the UBIKSTUDIO as well as the UBIK® web service.

  1. Open UBIKSTUDIO and connect to the database which should be configured for Single Local Application.
  2. Open database specific settings and set
    3. Parameter Value Comment
    SessionManagementType 0 0 = Single Local Management, 1 = LAS, 2 = GAS
    SessionServiceUrl - Address of the authentication service
    TokenValityPeriode 300 Duration (in seconds) every generated token is valid. The token expires after this timespan.
    HideAuthenticationInfo 1 This switch provides the possibility to turn off the detailed error information as necessary (due to security issues).
  1. Open the web.config of the data service and check values of the session's management type and URL.
    2.   <appSettings>
        ...
        <add key="UBIK.Service.TokenValityPeriode" value="600" />
        <add key="UBIK.Service.SessionManagementType" value="0" />
        <add key="UBIK.Service.SessionManagementUrl" value="" />
        <add key="UBIK.Service.HideAuthenticationInfo" value="0" />
        ...
      </appSettings>

See also

Retrieved from "https://wiki.augmensys.com/index.php?title=HowTo:Configure_Single_Local_Application_Authentication&oldid=10054"