Difference between revisions of "HowTo:Configure GAS Authentication"

Revision as of 09:26, 5 June 2014

Using the Global Application Service (GAS) authentication mode requires to configue the UBIKSTUDIO as well as the UBIK^® web service.

Parameter	Value	Comment
SessionManagementType	2	0 = Local Management, 1 = LAS, 2 = GAS
SessionServiceUrl	https://SERVERNAME/UBIK/USAM.svc/SOAP??	Address of the authentication service

Open the web.config of the data service and set the session's management type and URL to the according address of the web service.

Open the web.config of the GAS' USAM service:
- the settings in the configuration file are the same as in a data service
- however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored

This authentication mode is not yet supported!

@@ Line 1: / Line 1: @@
-A [[USAM#LAS_(Global_Application_Service)|Global Application Service (GAS)]] can be configured in the following way:
+Using the [[USAM#LAS_(Global_Application_Service)|Global Application Service (GAS)]] authentication mode requires to configue the {{UBIKSTUDIO}} as well as the [[UBIK_Web_Service|{{UBIK}} web service]].
+=== {{UBIK}} Studio ===
 <ol>
-<li>Open [[UBIK_Studio_Basics|UBIK Studio]] and connect to the database which should be configured for GAS.</li>
+<li>Open UBIKSTUDIO and connect to the database which should be configured for GAS.</li>
 <li>Open [[UBIK_Studio_Basics#Database_specific_settings|database specific settings]] and set</li>
 {| class="wikitable" | width = "50%"
@@ Line 12: / Line 14: @@
 |}
 </ol>
-<ol start="3">
+=== {{UBIK}} Web Service ===
+<ol>
 <li>Open the [[UBIK Web Service Configuration|web.config]] of the data service and set the session's management type and URL to the according address of the web service.</li>
 <source lang="xml">