Difference between revisions of "HowTo:Configure Logging"

Revision as of 12:18, 25 March 2014

Logging in UBIK^® can be configured for the Web Service as well as for the UBIK.Studio.

The logging for the Web Service can be configured via editing the Web Service Configuration in section loggingConfiguration:

1. Open UBIK Studio and connect to the database which should be configured for LAS.
2. Open database specific settings and set

Parameter	Value	Comment
SessionManagementType	1	0 = Local Management, 1 = LAS, 2 = GAS
SessionServiceUrl	https://SERVERNAME/UBIK/USAM.svc/SOAP??	Address of the authentication service

3. Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
  <appSettings>
    ...
    <add key="UBIK.Service.SessionManagementType" value="1" />
    <add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
    ...
  </appSettings>
4. If the authentication service is in a different location, open the web.config of the USAM service:
   
   • the settings in the configuration file are the same as in the data service
   • however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored

It is important that the authentication service connects to the same database as the data service!