Difference between revisions of "HowTo:Configure LAS Authentication"
m (Text replacement - "{{UBIKSTUDIO}}" to "{{UBIK Studio}}") |
|||
| Line 33: | Line 33: | ||
</li> | </li> | ||
</ol> | </ol> | ||
| + | |||
{{Attention|It is important that the authentication service connects to the same database as the data service!}} | {{Attention|It is important that the authentication service connects to the same database as the data service!}} | ||
| Line 40: | Line 41: | ||
* [[USAM#GAS_.28Global_Application_Service.29|Global Application Service]] | * [[USAM#GAS_.28Global_Application_Service.29|Global Application Service]] | ||
| − | [[Category: | + | [[Category:How-To|Configure LAS Authentication]] |
| − | [[Category: | + | [[Category:Installing|Configure LAS Authentication]] |
| − | [[Category: | + | [[Category:Session management|Configure LAS Authentication]] |
Latest revision as of 12:19, 22 July 2015
Using the Local Application Service (LAS) authentication mode requires to configue the UBIK® Studio as well as the web service.
- Open UBIK® Studio and connect to the database which should be configured for LAS.
- Open database specific settings and set
| Parameter | Value | Comment |
|---|---|---|
| SessionManagementType | 1 | 0 = Local Management, 1 = LAS, 2 = GAS |
| SessionServiceUrl | https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP?? | Address of the authentication service The port number PORT must be specified only if other than 443 (default for https). |
| TokenValityPeriode | 300 | Duration (in seconds) every generated token is valid. The token expires after this timespan. |
| HideAuthenticationInfo | 1 | This switch provides the possibility to turn off the detailed error information as necessary (due to security issues). |
- Open the web.config of the data service and set the session's management type and URL to the according address of the web service.
- If the authentication service is in a different location, open the web.config of the USAM service:
- the settings in the configuration file are the same as in the data service
- however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored
<appSettings>
...
<add key="UBIK.Service.TokenValityPeriode" value="600" />
<add key="UBIK.Service.SessionManagementType" value="1" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
<add key="UBIK.Service.HideAuthenticationInfo" value="0" />
...
</appSettings>
...
<add key="UBIK.Service.TokenValityPeriode" value="600" />
<add key="UBIK.Service.SessionManagementType" value="1" />
<add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME[:PORT]/UBIK/USAM.svc/SOAP" />
<add key="UBIK.Service.HideAuthenticationInfo" value="0" />
...
</appSettings>
 | It is important that the authentication service connects to the same database as the data service! |
