Jump to: navigation, search

Difference between revisions of "HowTo:Configure Single Local Application Authentication"

 
(9 intermediate revisions by the same user not shown)
Line 1: Line 1:
−
A [[USAM#Single_Local_Application|Single Local Application]] can be configured in the following way:
+
Using the [[USAM#GAS_(Single_Local_Application)|Single Local Application]] authentication mode requires to configue the {{UBIK Studio}} as well as the [[Web_Service|{{UBIK}} web service]].
 +
 
 
<ol>
 
<ol>
−
<li>Open {{UBIKSTUDIO}} and connect to the database which should be configured for Single Local Application.</li>
+
<li>Open {{UBIK Studio}} and connect to the database which should be configured for Single Local Application.</li>
 
<li>Open [[UBIK_Studio_Basics#Database_specific_settings|database specific settings]] and set</li>
 
<li>Open [[UBIK_Studio_Basics#Database_specific_settings|database specific settings]] and set</li>
 
{| class="wikitable" | width = "50%"
 
{| class="wikitable" | width = "50%"
Line 30: Line 31:
 
</ol>
 
</ol>
  
−
[[Category:How-To]]
+
== See also ==
 +
* [[USAM]]
 +
* [[USAM#LAS_.28Local_Application_Service.29|Local Application Service]]
 +
* [[USAM#GAS_.28Global_Application_Service.29|Global Application Service]]
 +
 
 +
[[Category:How-To|Configure Single Local Application Authentication]]
 +
[[Category:Installing|Configure Single Local Application Authentication]]
 +
[[Category:Session management|Configure Single Local Application Authentication]]

Latest revision as of 11:23, 21 July 2015

Using the Single Local Application authentication mode requires to configue the UBIK® Studio as well as the UBIK® web service.

  1. Open UBIK® Studio and connect to the database which should be configured for Single Local Application.
  2. Open database specific settings and set
    3. Parameter Value Comment
    SessionManagementType 0 0 = Single Local Management, 1 = LAS, 2 = GAS
    SessionServiceUrl - Address of the authentication service
    TokenValityPeriode 300 Duration (in seconds) every generated token is valid. The token expires after this timespan.
    HideAuthenticationInfo 1 This switch provides the possibility to turn off the detailed error information as necessary (due to security issues).
  1. Open the web.config of the data service and check values of the session's management type and URL.
    2.   <appSettings>
        ...
        <add key="UBIK.Service.TokenValityPeriode" value="600" />
        <add key="UBIK.Service.SessionManagementType" value="0" />
        <add key="UBIK.Service.SessionManagementUrl" value="" />
        <add key="UBIK.Service.HideAuthenticationInfo" value="0" />
        ...
      </appSettings>

See also

Retrieved from "https://wiki.augmensys.com/index.php?title=HowTo:Configure_Single_Local_Application_Authentication&oldid=16765"