View source for HowTo:Configure LAS Authentication

A [[USAM#LAS_(Local_Application_Service)|Local Application Service (LAS)]] can be configured in the following way:
<ol>
# Open ''[[UBIK_Studio_Basics|UBIK Studio]]'' and connect to the database which should be configured for LAS.
# Open [[UBIK_Studio_Basics#Database_specific_settings|database specific settings]] and set<!--
 --><p>
{| class="wikitable" | width = "50%"
|-
! Parameter!! Value!! Comment
|-
| ''SessionManagementType''|| '''1''' || 0 = Local Management, 1 = LAS, 2 = GAS
|-
| ''SessionServiceUrl''|| https://SERVERNAME/UBIK/USAM.svc/SOAP?? || Address of the authentication service
|}</p>
# Open the [[UBIK Web Service Configuration|web.config]] of the data service and set the session's management type and URL to the according address of the web service.
<source lang="xml">
  <appSettings>
    ...
    <add key="UBIK.Service.SessionManagementType" value="1" />
    <add key="UBIK.Service.SessionManagementUrl" value="https://SERVERNAME/UBIK/USAM.svc/SOAP" />
    ...
  </appSettings>
</source>

# If the authentication service is in a different location, open the [[UBIK Web Service Configuration|web.config]] of the USAM service:  the settings in the configuration file are the same as in the data service, however, the settings for the SessionManagementType and the SessionManagementUrl will be ignored. It is important that the authentication service connects to the same database as the data service!
</ol>

[[Category:How-To]]